![background image](http://html1.mh-extra.com/html/empire-comfort-systems/dvp36fp30n-5/dvp36fp30n-5_installation-instructions-and-owners-manual_2404095015.webp)
39358-3-1019
Page 15
INStALLAtIoN (CoNt’D)
Flush Wall Installation
Figure 15
Combustible Surround Installation
Figure 16
Attention: Cold climate installation recommendation: When
installing this unit against a non-insulated exterior wall, it is
recommended that the outer walls be insulated to conform to
applicable insulation codes.
Vent Runs
In planning the installation for the fireplace, it is necessary to
install certain components before the appliance is completely
positioned and installed. These include the direct vent system,
gas piping for the appliance and the electrical wiring. (If the fan
option is used.)
The appliance can be mounted on any of the following surfaces:
1. A flat, hard combustible (burnable) surface.
2. A raised wooden platform.
3. Four corner supports. (Example: Four concrete masonry blocks.)
These supports must be positioned so they contact all four perimeter
edges on the bottom of the unit (if allowed by local codes).
NotICE:
Discard insulation and retainer when venting from the
top of the fireplace. See page 23.
toP, 90° eLBoW WItH HoRIZoNtAL teRMINAtIoN
Propane and Natural Models
Figure 17
Summary of Contents for DVP36FP30N-5
Page 20: ...39358 3 1019 Page 20 Figure 29 Figure 30 Figure 31 EXAMPLES TOP VENT RUN...
Page 37: ...39358 3 1019 Page 37 Figure 57 DVVK 4FV DIRECT VENT TERMINATION KIT CONT D...
Page 46: ...39358 3 1019 Page 46 Figure 70 MILLIVOLT SYSTEM STANDING PILOT WIRING DIAGRAM...