![background image](http://html.mh-extra.com/html/empire-comfort-systems/dvcp36pp3-series/dvcp36pp3-series_installation-instructions-and-manual_2404063049.webp)
LOG & STONE PLACEMENT - DG30MX
Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs and rocks is critical to the safe and clean
operation of this fireplace. Sooting and other problems may result
if the logs are not properly and firmly positioned in the fireplace.
Refer to Figure 69 for the following warning.
WARNING
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
Attention: Do not use
Figure 69
to order replacement logs. Refer
to Page 47 - 48 Log and Rock Identification to order logs for your
appropriate model number.
NOTICE:
Once the installation is complete with the glowing
embers and log set in place, operate the fireplace to verify flame
appearance. If there are flames directly impinging a log, turn
off fireplace, then remove the glowing ember material directly
below where the flame impingement occurred. This should
eliminate sooting on the log, and provide a more pleasing flame
appearance.
Replacement of glowing embers must be purchased from an
Empire Comfort Systems Dealer. Application of excess glowing
embers may adversely affect performance of the fireplace.
WARNING
All previously applied loose material must be removed
prior to reapplication.
Log Placement Figure 69
FRONT VIEW - COMPLETED LOG SET INSTALLATION
(WITHOUT EMBERS)
Figure 70
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Burner Pin and Tab Identification - Figure 71
36092-2-0316
Page 49