Page 44
Programming and Configuring YOUR Components
You must enter the SETUP mode to program the re-
mote control for the other components in your system,
and to customize it for your convenience. There is only
one way to enter the SETUP mode: Hold down both
the MAIN and ENT buttons for a few seconds until
SETUP appears in the display.
The SETUP display shows 10 op-
tions.
P-PRO
LEARN
FAV
MACRO
PUNCH
RECAL
ERASE
EDIT
LIGHT
CLONE
Each of these setup options is described in the subse-
quent pages of this section. Please note that there are
multiple steps involved in each program sequence, so it
is best to read through the section thoroughly BEFORE
beginning to setup the DMC-1 remote.
P-PRO
The remote is pre-programmed to operate many types of equipment. The P-PRO mode al-
lows you to enter a 3-digit code to recall the commands for each of your system components.
1) Find the brand of your TV, DVD, VCR, CD and other components, then look at the tables at
the back of this manual. Make a note of the various codes for each piece. Note that some TV/
VCR combined units may use VCR codes, not TV codes.
2) Sit in a position in front of your equipment, and make sure that all components are turned
off.
3) In the SETUP mode, press P-PRO and the device labels will appear.
4) Select the device button you wish to program, then choose the device table you took the
code from. For example, for a TV, press TV twice. If you want AUX to control a VCR, press
AUX, then press VCR.
5) You can now enter a code using the remote’s keypad, or UP or DOWN. After the third digit
is entered, the remote transmits a power command. If the component turns on, press SAVE
and then EXIT.
6) If you could not find a code which works, hold the UP button to step through all the codes in
the table for that device. Release UP when your equipment turns on. If you go past, press
DOWN. Press SAVE and then EXIT.
SYSTEM
POWER
OFF
CD
DVD
VCR
SAT
TV
CABLE
TAPE
AUX
ZONE2
EMO
AUDIO
MAIN
PAGE
FAV
MUTE
PREV
CH
MENU
GUIDE
MODE
MODE
MAIN
EXIT
INFO
1
2
3
6
5
4
7
8
9
0
+10
DIS
ENT
M3
M2
M1
CH
VOL
REMOTE 1
MAIN Button
ENT Button
Press MAIN and ENT
buttons simultaneously
for 3 seconds to enter
the SETUP mode
Summary of Contents for DMC-1
Page 1: ...professional AV Processor USER S GUIDE...
Page 2: ......
