Emos M0430, Instruction Manual

Page: 16 / 200

16
3. Place the measuring tips onto the measured object (capacitor).
If it is e.g. an electrolytic capacitor, make sure to observe correct
polarity during measurement. (the red measuring cable should
be connected to the capacitor‘s positive pole, the black to the
negative pole).
The capacity value will appear on the screen.
Note:
When the capacity range is low, the displayed capacity value may
be unstable. In that case, the measuring tips were not connected
to the object (capacitor). This is normal behaviour and does not
affect measurement.
If the measured value is over 600 μF, it takes at least 10 seconds
for the value to stabilise.
Frequency and Duty Cycle Measurement
1. Connect the plug of the black (negative) tipped measuring
conductor into the COM socket and the plug of the red (positive)
measuring tip into the INPUT socket.
2. Switch to the function.
3. Connect the measuring tips to the object you want to measure.
4. Repeatedly press the Hz/Duty button to select voltage/cur-
rent frequency measurement or voltage/current duty cycle
measurement.
This device is not intended for use by persons (including children)
whose physical, sensory or mental disability or lack of experience or
knowledge prevents them from using it safely. Such persons should
be instructed in how to use the device and should be supervised
by a person responsible for their safety. Children must always be
supervised to ensure they do not play with the device.
Do not dispose with domestic waste. Use special collection
points for sorted waste. Contact local authorities for informa-
tion about collection points. If the electronic devices would be
disposed on landfill, dangerous substances may reach ground-
water and subsequently food chain, where it could affect human health.
You can request technical assistance from the supplier:
EMOS spol. s r. o., Lipnická 2844, 750 02, Přerov