EMKO ESM-7311-H, Instruction Manual, Page: 29 / 30

5. Failure Message in ESM-7311-H Heating Controller
Heating
Controller
ESM-7311-H
°C
SV PR
Heating
Controller
ESM-7311-H
°C
SV PR
Heating
Controller
ESM-7311-H
°C
SV PR
29
2- Blinking the Screen Value
If temperature higher than the alarm parameters limit, value on the
screen starts to blink
Example-2 :
If alarm function selection parameter
in programming section is
1 (Absolute Alarm) and maximum alarm parameter is 50
When temperature is above 50 °C, value on the screen starts to blink.
Also buzzer function selection parameter
is 2 or 4, then internal
buzzer is on.
Example-1 :
If alarm function selection parameter
In programming section is
1 (Absolute alarm) and minimum alarm parameter is 20 ;
When temperature is less than 20
, then
internal buzzer is on.
°C, value on the screen starts to
blink. Also if buzzer function selection parameter is 2 or 4
1- Probe failure in analog inputs.
When this message is on the screen, if buzzer
function selection parameter is 3 or 4 , internal buzzer starts to
operate.
Sensor connection is wrong or there is
no sensor connection.