EMF Motor EMF SQML160 Series, Operating Instructions Manual

Page: 21 / 43

20
www.emfmotor.com
1- Loosen the fixing frame of the encoder by using a 2 mm allen key.
2- Remove the protection cover of the encoder.
3- Loosen the fixing bolt (M5x47) of the encoder 1-2 turns by using a 4 mm allen key.
4- Use the M10x25 bolt as extractor and loosen the encoder.
5- Remove M5 bolt inside and take out the encoder from its slot.
INFORMATION
During dismounting, do not manually force the encoder to remove.
Mounting Process:
Drw-7
1- Place the encoder into its slot by hand and fix it by using M5x47 bolt. Manually check
the forward – backward movement of the encoder and make sure that is does not move.
(The tightening torque must be maximum 5 Nm.)
2- Fix the encoder protection cover.
3- Tighten the encoder frame bolt by using a 2 mm allen key, check the rotating
movement by hand and make sure that it does not rotate. (The tightening torque must be
maximum 1,25 Nm.)
CAUTION!
After the new encoder is installed, the encoder offset angle must be
readjusted via the driver. If it is not adjusted, this may cause uncontrolled
motor operation and very high speeds.