~ 15 ~
v. 1.03
shaft, and replace and tighten the 3 securing screws. Start the
screws threading into each hole before tightening any of them all
the way. Do not over tighten.
3) Bearing discs - the small centering hole in the bearing disc may
show signs of wear (oblonging) after many hundreds of batches.
To check this, insert the round end of the dasher shaft into the
bearing disc's hole. There should be some clearance, but equal all
around the hole. If questionable, replace the disc.
4) Power cord - be sure to keep the power cord routed in a safe
path to your outlet. If for some reason the cord becomes damaged
or frayed, or the plug does, have an electrician replace the entire
cord. You can purchase this part from Emery Thompson.
5) General cleanliness - aside from the normal day-to-day cleanup
of the machine, and to keep the machine looking it's best, a
stainless steel cleaner/polish can be used on all stainless surfaces to
bring back its luster. Do not use abrasive cleaners, or cleaners with
high bleach content.
Photo 5-1
Summary of Contents for CB-100
