Emerson ROSEMOUNT HMC-C01, Reference Manual

Page: 25 / 42

Reference Manual Installation
00809-200-4245 April 2022
Reference Manual 25
3.4.6 Connect the chain/ For Two Piece Chains.
• Connect each 10 ft. section using the included connecting link. Position the male
portion of the connecting link through the corresponding end roller links of the two
sections which are being connected. Position the female portion of the connecting
link over the male portion. Ensure that the connecting link “flats” are in the down
position. Snap the white top plate in place over the extended pin ends to secure the
connecting link.
3.4.7 Connection style may vary by chain series.
• To install the last section of chain, separate the chain to require length using a chain
breaker to push the appropriate connecting pins out of the roller base chain. Make
final connection to complete the chain loop.
•
For plastic two piece chains, white top plates are provided to aid in the location of
the connecting links in assembled chain loops. The connecting link may contain a
“flat” portion on the MO pin plate to aid in identification of the connecting link. While
866 chain is a two piece design, it contains a cotter pin and therefore, cotter pins
must be removed to disassemble the chain. This also means every link is a
connecting link.