Emerson Rosemount Analytical RDO, Manual

Page: 6 / 32

MODEL RDO INSTALLATION
6
FIGURE 1-4. Attaching the
mounting brackets
FIGURE 1-5. Back and side view of pipe-mounted analyzer
1.3.2 Pipe Mounting
1. Remove the four nuts and four screws from the
mounting kit.
2. Open the enclosure and drop one nut into each
drilled corner of the box (Figure 1-3).
3. Use a screwdriver to push the nut down and set it in
place (Figure 1-3).
4. Orient the two brackets on the back of the enclosure
so that the flanges on the brackets point downward
(Figure 1-4).
5. Attach the mounting brackets to the enclosure using
two screws for each bracket. Make sure that the
screws properly thread into the nuts you seated in
steps 2 and 3.
6. Place two hose clamps over the mounting pipe and
tighten them until they almost secure.
7. Place the flanges from the mounting bracket into
each of the hose clamps (Figure 1-3).
8. Tighten the hose clamps until the analyzer is secure
on the pipe.
FIGURE 1-3. Placing the nut in the enclosure