Instruction Manual
760000-C
November 2002
Rosemount Analytical Inc. A Division of Emerson Process Management Installation 2-1
Model NGA2000 CLD
ANALYZER MODULE GUIDES
PIN SEATS
DISENGAGED FRONT PANEL
SECTION 2
INSTALLATION
WARNING
.
Before starting to install this equipment,
read the “Essential Instructions” on the in-
side cover and the Safety Summary begin-
ning on page P-2. Failure to follow the safety
instructions could result in serious injury or
death.
2-1 UNPACKING
If the Chemiluminescence (CLD) Analyzer Mod-
ule is received as a separate unit, carefully ex-
amine the shipping carton and contents for
signs of damage. Immediately notify the ship-
ping carrier if the carton or contents is dam-
aged. Retain the carton and packing material
until all components associated with the CLD
Analyzer Module are operational.
2-2 ASSEMBLY
If the CLD Analyzer Module requires assembly
with other components (e.g., the Platform and
associated I/O Modules), do so at this time. Fol-
lowing the guides on the bottom left and bottom
center of the Platform, carefully slide the Ana-
lyzer Module halfway into place.
CAUTION
.
HAND INJURY HAZARD
Do not place hands or fingers in Platform
front handles when the front panel is open.
Dropping front panel while hand or fingers
are inside either handle can cause serious
injury.
Lift the spring-loaded pins on the front of the
Analyzer Module, and carefully slide it the rest
of the distance. Secure the module in position
by releasing the pins, which seat in the available
holes in the bottom of the case (see Figure 2-1,
below). If the module and Platform are difficult
to assemble, remove the module, ensure the
top cover of the module is firmly seated on the
hold-down screws, and repeat the assembly
procedure.
Refer to Section 2-5, page 2-4 for electrical
connections.
Install I/O Module(s) according to guidelines in
the I/O manual. After startup and calibration
have been performed, secure the front panel
with the six screws provided.
Figure 2-1. Analyzer Module Installation into Instrument Platform
