Instruction Manual
760000-C
November 2002
8-2 Index
Rosemount Analytical Inc. A Division of Emerson Process Management
Model NGA2000 CLD
More, 3-2
NEXT, 3-24
RSTR MN, 3-25
RSTR ST, 3-25
Status, 3-2
STORE, 3-24
Function Line, 3-2
G
Gas measurement, 3-18
H
Health, 3-20
heater, 4-1, 4-3
heater jacket, 4-1
hold output during calibration, 3-28
hysteresis level, 3-17
I
I/O Module
installation, 2-1
Inlet/Outlet fittings, 2-2
Interference, 3-20
invert signal, 3-30
L
LCD brightness and contrast, 3-7
Leak Test, 2-4
linear polynomials, 3-14
linearization curve must be monotonic, 3-16
Linearizer, 3-20
Load configuration data from serial interface, 3-34
Loading/saving configuration parameters, 3-32
LON update rate, 3-17
M
main power fuse, 4-1
Maximum permissible interval between calibrations,
3-7
measured conversion efficiency, 3-39
Measurement mode, 3-20
Measurement range number, 3-10, 3-12
Menu Line, 3-1
Midpoint Correction Set Up, 3-16
Monotonic, 3-16
N
NO/NOx, 3-20
NO/NOx flow balance, 3-34
Noise level, 3-20
O
operation mode, 3-28
adjust 0V, 3-28
adjust 10V, 3-28
normal, 3-28
Operational state, 3-20
output current, 3-28
output delay time, 3-17, 3-20
output number, 3-30
Output number, 3-28
output(s) value on analyzer failure, 3-28
Ozonator, 3-20
Ozonator Power, 3-10
Ozonator Source Gas, 2-3
P
photodiode, 1-1, 3-20, 4-4
PIN, 3-35
point to be measured, 3-16
power failure, 3-1
Power Supply Board, 4-1
Power Supply Board main power fuse, 4-1
Power supply voltages, 3-33
ppm to mg/Nm3 conversion factor:, 3-18
Pressure, 2-3
Pressure measurement, 3-18
Primary variable parameters, 3-33
R
Range and functional control, 3-12
Raw signal, 3-20
Reaction Chamber, 4-3, 4-4
Replace current configuration with factory settings,
3-35
response time, 3-17
Return Authorization, 7-2
S
Sample, 2-3
maximum flow, 2-3
sample contaminates, 4-1
Sample flow, 3-20
Sample line tubing type, 2-2
Sample press, 3-20
security codes, 3-32
Security codes
enabled, 3-36
lost or forgotten, 3-35
select analog output number, 3-26
Send configuration to serial interface, 3-34
serial interface options, 3-29
Set up a new date or time, 3-35
