NEOTECHA
NTB-NTC BALL VALVES
INSTALLATION AND MAINTENANCE INSTRUCTIONS
Before installation these instructions must be fully read and understood
1 GENERAL INFORMATION ON THE
INSTALLATION AND MAINTENANCE
INSTRUCTIONS
These instructions contain information on
how the valve should be safely installed and
operated in the prescribed manner. If any
problems are encountered during installation
or operation which cannot be resolved with
the aid of the installation and maintenance
instructions, please contact the supplier or
manufacturer for more information.
These installation and maintenance
instructions comply with the applicable
EN safety standards.
When installing the fitting, the operator or
the person responsible for the design of
the installation must ensure that applicable
national regulations are complied with.
The manufacturer reserves all rights to
make technical changes and improvements
at any time.
The use of these installation and maintenance
instructions assumes that the user is qualified
to “Qualified Personnel” level. Operating staff
must be given appropriate training in the
operating and maintenance instructions.
2 SAFETY
Please also read through these notes carefully.
2.1 General potential danger due to:
a. Failure to observe the instructions
b. Improper use
c. Insufficiently qualified personnel
2.2 Correct use
2.2.1 Area of application
Ball valves are bubble-tight shut-off industrial
valves that can be used for the isolation,
throttling and regulation of corrosive gases,
liquids, pastes and powder products in
pipelines, vessels, apparatus etc.
The surfaces of the of the body parts, together
with the ball or C-core that are in contact
with the medium are coated with PFA. Ball
seats and control orifice plates are available
in various material types and can be used to
suit the medium.
Emerson.com/FinalControl
© 2017 Emerson. All Rights Reserved.
VCIOM-01973-EN 15/02
2.2.2 Performance data
Nominal diameter range:
DIN-PN 16 and JIS 10K
DN 15 / 20 / 25 / 40 / 50 / 65 / 80 / 100 / 150
(ANSI 6” face-to-face with extension)
ANSI 150 lbs
½”, ¾”, 1”, 1½”, 2”, 2½”
(DIN face-to-face), 3”, 4”, 6”
Pressure range:
16 bar (0.1 mbar vacuum)
Test pressure = 1.5 x PN = 24 bar
Temperature range:
-40°C to 180°C
