9
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF995-1
3. Ceiling Fan Assembly
(continued)
MOTOR COUPLER
10" DOWNROD
MOTOR COUPLER
COVER
MOTOR COUPLER
COVER GROMMET
Figure 15
3.15
Make sure the Grommet is properly installed in the Motor
Coupler Cover.
Slide the Motor Coupler Cover on the 10” Downrod until it
rests on the Motor Housing. Be sure the Motor Coupler
Cover is oriented correctly (Figure 15).
CLEVIS PIN
HAIRPIN
CLIP
HAIRPIN
CLIP
CLEVIS
PIN
MOTOR
COUPLER
Figure 13
3.13
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 13).
The Clevis Pin must go through the Holes in the Motor
Coupler and Downrod. It is critical that the Clevis Pin in the
Motor Coupler is properly installed and securely tightened.
RETIGHTEN TWO
PHILLIPS HEAD
SET SCREWS
MOTOR COUPLER
10" DOWNROD
Figure 14
3.14
While pulling up on the 10” Downrod, retighten the Two
Phillips Head Set Screws to secure the 10” Downrod in
the Motor Coupler (Figure 14).
NOTE: The Set Screws must be properly installed as
described above, or fan wobble could result.
It is critical that the clevis pin in the motor coupler is
properly installed. Failure to verify that the pin is properly
installed could result in the fan falling.
WARNING
!
It is critical that the set screws in the motor coupler are
properly installed and securely tightened. Failure to verify
that the set screws are properly installed could result in
the fan falling.
WARNING
!