10
ETL Model No.: CF995-1
3. Ceiling Fan Assembly
(continued)
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure to
verify that the pin and set screw are properly installed
could result in the fan falling.
WARNING
!
3.16
Place the Ceiling Cover over the 10” Downrod.
Be sure the Ceiling Cover is oriented correctly (Figure 16).
10" DOWNROD
CEILING
COVER
Figure 16
3.17
Route the Two Motor Wires through the Hanger Ball.
Reinstall the Hanger Ball (Figure 17) on the Downrod as
follows:
Position the Pin through the Two Holes in the Downrod
and align the Ball so the Pin is captured in the Groove in
the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and securely
tighten the Set Screw in the Hanger Ball.
NOTE: A loose set screw could create fan wobble.
HANGER BALL
PHILLIPS HEAD
SET SCREW
PIN
10" DOWNROD
Figure 17