Emerson HF948BS02, Owner'S Manual

Page: 17 / 72

17
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: HF948 & HF956
KNOB
WALL CONTROL
Figure 29
6. Wall Control Installation
(Continued)
6.12
The Wall Control is supplied with a white and almond
knob. Select the knob that matches the color of existing
faceplate (Figure 29).
Press knob onto the shaft of the Wall Control.
Rotate knob counter-clockwise to the full OFF position.
To Complete Installation:
Restore power at the main
fuse box or circuit breaker panel.
6.13
SW95 Single Fan Wall Control Wiring (Figure 30).
TO NEUTRAL
TO FAN MOTOR LOAD
TO 120VAC
SOURCE HOT
SW95 SINGLE FAN
WALL CONTROL
BLACK
BLACK
BLACK or RED
BLACK
GREEN
GREEN
Figure 30
6.14
After completing installation, test run fan in normal
operation manner. Inspect for any possible shake or
wobble which may be caused by binding as a result of
"tight cable". if this should happen, shut off power supply
and re-check instructions to correct problem.
NOTE: When any solid state motor speed control is
used, a humming noise may be present in the fan on
low speed. This hum in no way affects the operation
of the fan and is acceptable in most installations.