COMPONENTS IN THIS PACKAGE
SST-FLTR
Filter Head
3/8" Tubes (2)
6" Filter
Discharge Tube
Filter Cartridge
Brass Nut/Ferrule/
Tube Insert
F-HC1100
F-GN1100
F-HC2215
F-GN2215
F-HC2200
F-GN2200
Semi-circular
Mounting Plate
Rubber O-Ring
Hex Nut
Brass Seat
(HC3300, H3300)
Hex Tool
Snap-Connect
Fitting (3 pieces)
3/4" Screws (4)
Y-Quick Connector
F-H3300
F-HC3300
Plug (1)
4
B
Turn off water supply.
At tank top, depress release ring or
gray release tab into quick-connect
fitting securing
blue
or
copper
1/4"
tube and gently pull line off tank
fitting. Pull
white
7/16" tube and
clear
5/16" tube off fittings.
If not already equipped, the included
snap-connect fitting must be installed.
To install snap-connect fitting,
unscrew brass mounting nut and
remove snap-connect fitting, brass
ferrule and nut.
A
Slide brass nut and plastic ferrule
onto the 1/4"
blue
or
copper
tube
running from the faucet.
Insert
blue
or
copper
tube into snap-
connect fitting and tighten brass nut
with a wrench, 1 to 2 turns clockwise.
You may elect to use existing tank
mounting bracket.
Skip to Page 9, Steps 3-4 for
complete installation instructions.
A
Turn off water supply.
Remove tubes from tank: At tank
top, depress gray release tab into
quick-connect fitting securing
blue
or
copper
1/4" tube and gently pull
line out of fitting. Pull
white
7/16"
tube and
clear
5/16" tube off fittings.
Remove existing faucet and continue
to page 6.
Blue Tube
Property Damage:
Do not over tighten brass nut.
Property Damage:
Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
Property Damage:
Unplug tank
before disconnecting tubing.
IF INSTALLING ONLY NEW TANK
Release
Tab
1/4"
blue
7/16"
white
5/16"
clear
Check
orientation
of ferrule
Make note of
orientation
of ferrule
IF INSTALLING ONLY NEW FAUCET
5
If installing
BOTH
new faucet and new tank, skip to page 6.
