Apply thread locker onto mounting location
Figure 3-4:
3.
Using a 1/8 in. Allen key (English mounting stud) or a 4 mm Hex Allen key (metric
mounting stud), loosely screw the mounting stud into the mounting location.
The mounting location is the machine surface when using stud mount and the
mounting pad when using epoxy mount.
4.
Using a torque wrench with 1/8 in. hex bit, torque to 7–8 ft-lb (9.5–10.8 N-m) to
tighten the mounting stud.
Tighten the mounting stud
Figure 3-5:
Setup
MHM-97408, Rev 15
75
Summary of Contents for CSI 9420
