Emerson Bettis SCE300, Installation, Operation And Maintenance Manual

Page: 4 / 67

II
Table of Contents
February 2020
Installation, Operation and Maintenance Manual
MAN-02-04-99-0712-EN Rev. 1
Table of Contents
Section 5: Lubrication
5.1 Lubrication Inspection................................................................................. 28
Section 6: Actuator Configuration
6.1 Removal of the Control Unit Cover .............................................................. 29
6.2 Local Configuration of the SCE300 .............................................................. 30
6.2.1 SCE300 Default General Configuration ............................................. 30
6.2.2 Close Limit Configuration by Position ............................................... 33
6.2.3 Close Limit Configuration ................................................................. 33
6.2.4 Open Limit Configuration by Position ............................................... 33
6.2.5 Open Limit Configuration ................................................................. 34
6.2.6 Close Limit Configuration by Torque ................................................. 34
6.2.7 Open Limit Configuration by Torque ................................................. 34
6.2.8 Stroking Time Selection in Closing.................................................... 35
6.2.9 Stroking Time Selection in Opening.................................................. 36
6.2.10 Setting of the Torque-Limiting Device in Closing .............................. 36
6.2.11 Configuration of the Torque Limiting Device in Opening ................... 37
6.2.12 Reverse Mode Configuration ............................................................ 37
6.2.13 Actuator Model Selection ................................................................. 38
6.2.14 Blinker / Local Selector Configuration ............................................... 40
6.2.15 Three-Wires (3-Wires) / Two-Wires (2-Wires)
Remote Control Configuration ......................................................... 40
6.3 Configuration of the SCE300 via PDA / PC and ‘A Manager’ Software ........... 41
6.4 Hardware Configuration for Monitor Relay .................................................. 41
Section 7: Maintenance and Troubleshooting
7.1 Maintenance ............................................................................................... 42
7.1.1 Routine Maintenance (approximately every two years) ..................... 42
7.1.2 Special Maintenance ......................................................................... 43
7.2 Troubleshooting .......................................................................................... 43
7.2.1 The Electronics do not Switch on when Powered .............................. 43
7.2.2 24 V DC Output Voltage not Available at the Terminals ..................... 44
7.2.3 The Actuator does not Work from Remote Controls ......................... 44
7.2.4 The motor is Very Hot and does not Start ......................................... 44
7.2.5 The Motor Runs but the Actuator does not Move the Valve ............... 44
7.2.6 The Valve does not Seat Correctly ..................................................... 45
7.2.7 Excessive Torque for Valve Operation ................................................ 45
7.2.8 The Actuator does not Stop in Fully Open or Fully Closed Position ..... 45
7.2.9 Diagnostic LED ................................................................................. 45
Section 8: Decommissioning
8.1 Disposal and Recycling ................................................................................ 46
Section 9: Parts List and Drawings