4
emcotherm
control technology
Subject to technical changes without prior notice! June 2008
Important Information and User Instructions
1
General introduction
1.1
emcotherm control technology offers products that are individually
harmonised to the needs of the convector market. This technology
has been developed in an environmentally-friendly and effective way
according to the latest state of technology.
Centralised and decentralised controlled and set switching functions
allow emcotherm control technology to be matched perfectly to the
product interfaces of leading manufacturers of convectors.
emcotherm control technology primarily consists of the following
components:
Connection box with integrated control board
→
In emcotherm floor convectors, the connection box is installed in
→
the convector at the factory and is ready for connection (see chapter
“Electrical Connection“ in the accompanying emcotherm convector
manual)
Components for individual room temperature control (see chapter 3
→
in this manual)
Accessories for control components (see chapter 4 in this manual)
→
Recommended uses and operation of emcotherm control components
can be found on the following pages of this manual.
Why you should read this manual
1.2
This manual has been prepared to the best of our knowledge. In
particular this manual describes the areas of use, operation and
proper installation of the various emcotherm control components. It
should make the operator, user and maintenance personnel familiar
with the setup, functions, operation and maintenance as well as the
safety factors of these control components. This manual also contains
important information and descriptions for professional fitting and
installation of the emcotherm control components when used with
emcotherm convectors. It is therefore mainly intended for trained and
qualified personnel.
Please keep this manual in a safe place, so that you can refer to it
whenever necessary. Also be sure to pass this user information on to
subsequent owners.
214OI_control_technology_GB_id8506280_0890112.pdf 4
12.01.2009 12:11:42 Uhr