Quick operation guide
Turning ON your AV equipment
•
To operate your Audio Visual (AV) components, press the volume
button on any existing remote control. This will apply power to all
components making them ready for use. Now use your existing
remote(s) to operate your television or other Audio Visual (AV)
components in the normal way.
Turning OFF your AV equipment
•
Simply turn your equipment off in the normal way. The Embertec
Emberstrip® 8AV+ will then remove power from the Power Saving
outlets after a delay of approximately 1 minute.
Active Powerdown®
•
If your Embertec Emberstrip® 8AV+ has not detected use of a remote
control for 1, 2 or 8 hours (depending on your settings), Active
Powerdown® will shut down power. The LED light on the RF4CE
Smart Sensor will flash for approximately 10 minutes to warn you
.
A flashing light means
the system is getting
ready to shut down.
TO CONTINUE
USING YOUR
EQUIPMENT
Press the volume
button on your
remote control.
NOTE:
To reactivate your TV components, you may be required
to press the power button again on the relevant remote
control after power has been restored. You may hear a
‘click’,
or notice that the TV standby light has switched on.
NOTE:
The LED light on the RF4CE Smart Sensor will flash
for about 60 seconds to warn you that power is about to be
removed from the AV Power Saving outlets.