Embertec Emberstrip ESUSAV8-ET-10D, User Manual, Page: 13 / 21

BedroomMode™ settings
Your RF4CE Smart Sensor is equipped with a unique feature which
enables you to reduce the brightness of the RF4CE Smart Sensor
‘flash’ and to reduce the length of flashing when your equipment is
no longer being used.
Your device is shipped with the brightness level set to maximum,
however you may wish to enable BedroomMode™ to reduce
the brightness of the RF4CE Smart Sensor light in a bedroom.
BedroomMode™ is not recommended for living rooms or brightly
lit areas.
To set bedroom mode using the RF4CE Smart Sensor:
Make sure that at least your TV is switched on before starting.
1.
Press and hold the SET button on the RF4CE Smart Sensor for
3 seconds then release. The LED light on the front of the sensor will
flash, starting from a faint flash slowly progressing to a bright flash.
2.
When you are happy with the level of brightness, press the SET
button on the RF4CE Smart Sensor again.
3.
You can change the brightness of the RF4CE Smart Sensor at any
time by following the above steps.
12
NOTE:
When BedroomMode™ is selected, the RF4CE Smart Sensor
will flash for 10 seconds once the television is turned off. Power
will be cut to the power saving outlets after another 50 seconds.
To adjust the RF4CE Smart Sensor to flash for one minute, press
the MUSIC button instead of the SET button at step 2.