© 2020 Embedded Data Systems, LLC.; 2019 Fortune Drive; Lawrenceburg, KY 40342; Phone/Fax 502-859-5490 3 / 10
EN-USERMAN MN-RTD4W-H V1.0 10.09.2020
RTD1Ohms, RTD2Ohms
Current Ohms readings, displayed in 0.001
Ω resolution. A reading of 0Ω indicates the probe is not connected.
RTD1Fault, RTD2Fault
Identifies RTD wiring issues. “0” is good. A reading of “1” indicates a problem.
TimeStamp
The date and time when the temperature readings are taken.
Battery
Displays voltage of the battery.
PowerSource
A special order variant is available that allows the RTD Input to be powered by inline or battery power. A reading of “1”
indicates battery power. A reading of “0” indicates currently receiving inline power.
OPERATIONAL PARAMETERS
Name
The Name or ID used to indicate the sensor model in the Controller. A list of the current IDs is available at the
Environmental Sensor IDs section
EUI
The EUI, or Extended Unique Identifier, is a globally unique 64-bit number, represented by 16 hexadecimal digits. This
number can be used by software to uniquely identify every MeshNet wireless device.
ControllerRSSI
This indicates the strength of the radio signal at the controller; higher numbers equate to stronger signals. Due to
hardware limitations, the highest number that can be displayed is -34 dBm. However, the actual signal strength may be
much higher.
DeviceRSSI
This indicates the strength of the radio signal at the sensor. Due to hardware limitations, the highest number that can be
displayed is -34 dBm, however the actual signal strength may be much higher.
Address
This is the address of the sensor, which was assigned by the controller.
Repeater
When the repeater joins the controller, it is assigned a repeater number, which is displayed here. A zero indicates there is
no repeater in the communication path.
Health
This is a number ranging from 0 to 7; 0 is not connected and 7 is healthy. The number is incremented when a packet is
received from the repeater and decremented when two packets are not received after a predetermined period of time.
Numbers less than 7 other indicate a weak
wireless link or other problem.
Version
This indicates the firmware version of the sensor.
UserName
The user programmable string used to identify any given Sensor; it may be up to 29 characters long. It is saved in non-
volatile memory so it is retained even when power is cycled. The string is best used as a human readable label, which can
uniquely identify each MeshNet RTD Input.
3
During initial configuration readings below 7
