P a g e
|
7
3.
IMPORTANT SAFETY INSTRUCTIONS
Warning:
The user guide you are holding includes essential information on the safety
measures to be implemented for installation and start-up. Therefore, the installer as well as
the user must read the instructions before beginning installation and start-up.
Keep this
manual for future reference.
The pump should be installed according to your local electrical installation ordinances and regulations.
Only qualified, licensed personnel should install the pump and the wiring.
This appliance cannot be used by persons (including children) with reduced physical, sensory or
mental capabilities or lack of experience and knowledge unless they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children must not play with the appliance.
Warning:
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
4.
INSTALLATION
4.1 Piping
•
Install the pump as close to the pool as possible, preferably in a dry, well ventilated area away from direct
sunlight. Protect the pump from excessive moisture.
•
Place the pump as close to the water
source as possible, so that the suction pipe
is short, straight and direct to reduce the
friction loss. Don't install the pump at more
than 10 ft (3 meters) of geometrical height
from water level.
•
Before installing the pump, make sure
that the surface is solid, elevated, rigid
and vibration free.
•
Secure the pump to the base with screws
or bolts to limit the vibration and the
stress on the pipe or the joints.
•
Leave enough space for gate valves in suction and discharge piping, if required.
•
Connect the suction and discharge pipe to the outlet and inlet of the swimming pool.
•
Make sure that floor drainage is adequate to prevent flooding.
•
Make sure that the pump and piping are accessible for servicing.
Note: The pump suction and discharge connections are mounded in thread
stops, DO NOT try to screw the pipe beyond these stops.
The two sets 1.5” union adaptor are universal design for metric and imperial
PVC pipe connection.
Summary of Contents for SPV150
Page 23: ...P a g e 23 Page 1 Page 2...
