P17
4.2.2
.
13
Paragraph 13 – Flow Display Unit
Programming
Operation
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the key,
then using the keys to set the unit of
m e a s u r e m e n t , c h o o s i n g b e t w e e n L / h
( l i t r e s / h o u r ) , G p h ( G a l l o n s / h o u r ) , m l / m
(millilitres/minute) or standard (% or frequency,
depending on settings). Press to confirm
and return to the main menu.
4.2.2
.
14
Paragraph 14 – Setting the Pause
Programming
Operation
The pump can be paused by remote input.
The factor y setting is Normally Open.
Changes can be made by pressing the key,
thenusing the keys to set the new value
( N.OPEN or N. CLOSED).
Press to confirm and return to the main
menu.
4.2.3
pH calibration Menu
Pressing the CAL key for 3 seconds takes you into the calibration menu. If calibration was excluded
during programming, the following appears on the display:
If calibration is active : It is possible to select automatic or manual mode. In both cases, it is
automatically calibrated to pH 7.
PROG
PROG
Configuration
Unit
Standard
enter
Unit
Standard
< -
Unit
L/H
enter
PROG
Paus
N.Open
enter
enter
PROG
Configuration
Calibration
Off
