UNPACKING
ENGLISH
4.2.5 SUSPENSION ASSEMBLY
Unscrew the two central screws on the rear plate of the mowing machine.
Place the suspension so that its fastening holes coincide with the threaded holes.
Fasten the suspension by means of the previously unscrewed screws.
4.2.6 GRASS COLLECTION BIN ASSEMBLY
The grass collection bin is preassembled, it is necessary to mount it to the machine and adjust it.
Take out the grass bin from the crate, open the bag
1
, tilt down the front tube
2
, insert the upper screws
3
and
4
, and tighten them slightly.
Suspend the grass bin prepared in this way onto the rear part of the mowing machine, align it with the mudguards and tighten screws
3
and
4
firmly.
Removethe grass bin from the machine and put it on its rear handle with the inlet opening facing upwards. Unscrew the nuts from screws
20
under the lid
and insert corner reinforcements
5
under the upper and bottom tubes. Screw the nuts on screws
20
and tighten them firmly.
Tilt down left support
6
and right support
7.
Insert the bottom tube
8
into the bag. Connect bottom tube
10
from outside of the grass bin usingscrews
11
,
and tighten these screws firmly. Attach tube
8
to the front tube
2
and to the corner reinforcementsusing screws
9
.
Grass collection bin 360 l:
Connect the second bottom tube
12
from outside of the grass bin using screws
13
. Insert the upper handle into the holes in the lid, attach sheet
14
to the bottom
side of the lid and fasten the handle and sheet usingnuts
15
.
Grasp the grass collection bin (300 l / 360 l), suspend it on the brackets on the rear plate of the mowing machine, and make sure it is aligned with the mud-
guards. If there is any deviation, loosen the screws, readjust the bin position and retighten the screws.
If it is not possible to align usingthe method stated above, perform the adjustment by shifting the brackets on the rear plate.
After adjusting, take down the grass bin from the machine, tighten all the screws and attach the bag to the frame using the plastic clips.
Pass lifting lever
18
through the upper hole in the lid and attachit with the M5x12 screw and nut.
Attach contact spring
19
of the safety switch.
Check the tightness of all screws and nuts.
300 l GRASS BIN
360 l GRASS BIN
4.2.7 GRASS COLLECTION BIN SUSPENSION
Grasp the assembled grass collection bin (300 l / 360 l) with both hands and lift it.
Tilt it so that is reclined inthe 40° angle and suspend it from the brackets on the machine rear plate.
After correct installation, stick the triangles (yellow self-adhesive labels) on the bin and machine so that their tops are opposite each other.
Check the correct function of the safety switch.
When the lid is closed,contact spring
19
of the safety switch must keep the switch in the switched on state.
13
Summary of Contents for EF105J
Page 11: ...10 TECHNICAL PARAMETERS ENGLISH...
