19
To move to the right, use key
and to the left use key
. Modify the values by means of the keys
.. .
. On
completion confirm by means of
. If the values are correct the display then shows:
If there is an error, for example if the month is set as 88, modifications are rejected and the rectangle moves to the position of the
error:
The weekday does not need to be entered as it is calculated automatically.
2.3.
MONITOR/INTERPHONE CONFIGURATION MODIFICATION
Press
to go to the next item in which the user can program the values of a number of flags, programmable keys and call
groups for each monitor/interphone Programming is by means of low level messages sent to the bus of the Elvox 2-wire system,
querying individual monitors/interphones, referred to below in general as “Devices”. For this reason answers to queries or modifi-
cations are not immediate.
In the preliminary procedure for this function, use keys
and
to select the device required
The device type is shown on the second line. The device software version number appears on the right:
If this is not present, the display shows:
Otherwise, enter the device number, from 1 to 200:
To cancel press
. To confirm, press
.
After selecting the required device, press the key
to start viewing/modifying the various parameters The data displayed
depends on the type of device and software version The following table summarises the information available for each device.
2.2.19.
Clock
The clock can be programmed so that the alarm service is performed correctly The date and time are stored also when the swit-
chboard is switched off, for at least 2 days, by means of a SuperCap capacitor There are no batteries of any type. On initial acti-
vation of the clock, or when the switchboard is left switched off for a prolonged period, the date is set to the 1st January 2005 and
the time at 00:00
It can be modified via the keypad. Press the key
. The modifiable field is indicated by a rectangle to the right:
