10
2.2.2.
MESSAGE LANGUAGE
Programming can be in Italian (default local language) or English Other local languages will be available for the respective markets
To change language, press
for Italian or
for English
To cancel press
. To confirm, press
.
Acceptance of the command, as in all cases, is shown on the first line of the display:
The display now changes to:
Use the key
to move to the previous item in the programming menu.
2.2.3.
Switchboard ID
Press
to move to the next item in which the switchboard ID can be changed To change the ID, enter a number between 1
and 4.
To cancel press
. To confirm, press
. Acceptance of the command, as in all cases, is shown on the first line of the
display:
If the ID is outside the admissible range, the first line of the display shows the error:
Use the key
to move to the previous item in the programming menu.
2.2.4.
Coding digit number
Press
to move to the next item in which the numbering used by the switchboard can be changed
The modes are as follows:
•
Sequential encoding (default): the monitors and interphones are numbered from 1 to 200. The numbering can be abbre-
viated.
To specify the first monitor, simply enter 1 rather than 001
•
4-digit encoding: the monitors and interphones are numbered from 0000 to 9999. 4 digits must always be used
•
8-digit encoding: the monitors and interphones are numbered from 00000001 to 99999999. 8 digits must always be used
To change the numbering mode, enter:
•
for sequential encoding
•
for 4-digit encoding
•
for 8-digit encoding
To cancel press
. To confirm, press
. Acceptance of the command, as in all cases, is shown on the first line of the
display:
If sequential encoding is not selected, the code remapping table must also be compiled.
Use the key
to move to the previous item in the programming menu.
