Press
to cancel. Press
to confirm. As with all com-
mands, implementation is confirmed on the first line of the di-
splay.
Press
to move on to the next item in the programming
menu.
5.7.
COMMON LOCK RELEASE
Press
to move to the next item and program what lock
actions the interface must notify DigiBus of. In practice the lock
release output of the DigiBus entrance panel downstream can
be activated either by a direct command or indirectly, if the lock
of another ELVOX TWO-WIRE entrance panel (up to a maxi-
mum of four) is released. This parameter is left blank by default.
Enter a number between 1 and 15, being the ID of the entrance
panel (in this case the first of four possible choices) to whose
lock release the interface must respond.
Press
to cancel. Press
to confirm. As with all com-
mands, implementation is confirmed on the first line of the di-
splay.
The display warns you if the value you enter is out of range.
Enter 0 as the ID to cancel assignment. Press
and
to move between one identity and another. In position 1, press
to move on to the next item in the programming menu.
Press
to skip all intermediate steps and return directly to
the previous item in the programming menu.
5.8.
F1 COMMON
Press
to move to the next item and program what lock
actions the interface must notify DigiBus of. In practice the F1
output of the DigiBus entrance panel downstream can be acti-
vated either by a direct command or indirectly, if the F1 output
of another ELVOX TWO-WIRE entrance panel (up to a maxi-
mum of four) is activated.
This parameter is left blank by default. Enter a number between
1 and 15.
Press
to cancel. Press
to confirm. As with all com-
mands, implementation is confirmed on the first line of the di-
splay.
+ D
+ D
+ D
+ D
Then press
.
To enter a number, simply key in the relevant digits.
Press
to delete the last digit.
If you enter fewer than the 4 or 8 digits required, any blank spa-
ces to the left are filled with ‘0’s.
Press
to cancel. Press
to confirm. The programmer
now checks that the number entered is not already associated
with another position.
If it is, you are notified as follows. In this example you are war-
ned that the code 7856 is already associated with the device
identity 99. If no clashes are found, implementation of the
change is confirmed on the first line of the display.
Press
to delete all numbers starting from the location of
the current value.
You are asked to press
to confirm.
then
. Press
or with
to cancel the proce-
dure. If you choose to proceed with the number reset, the di-
splay reads out:
Then, finally:
5.6.
NUMBER OF RING TONE CYCLES
Press
to move to the next item and change the number of
ring tone cycles sent by the interface to the ELVOX TWO-WIRE
wiring pillar. Ring tones follow a rhythm of 1 second of sound to
2 seconds of pause, so that each complete cycle lasts 3 se-
conds. The figure shown is the current setting:
Enter a new number to change the number of cycles:
+ D
GB
7/16
69DM
