5
www.eltherm.com
5
www.eltherm.com
INSTALLATION AND SAFETY INSTRUCTIONS
SPECIAL CONDITIONS
GOODS RECEIPT
STORAGE
i
i
i
DISPOSAL
DECLARATION OF CONFORMITY
•Electrical connection / commissioning must be carried
out by a qualified electrician.
•The relevant local safety regulations must be observed.
•Observe the connection values according to the rating
plate.
•Avoid tensile stress and torsion of the connected
cables
CAUTION
WARNING
Before starting work on
heating or connection cables or connection
terminals is to ensure that the corresponding circuit is
switched off and is secured against unintentional
restart
CAUTION
The sensor lines must be shielded
when extended, the shielding must be grounded on
one side close to the controller. The line must not be
laid parallel to lines carrying mains voltage. The total
line resistance must not exceed 10 ohms.
After switching on the controller, the
display shows the current actual value.
NOTE
Storage should be in a dry place at an
ambient temperature of 0°C to 50°C.
NOTE
The WEEE logo (shown above) indicates
that this product should not be disposed of with your
household waste.
You can obtain more information on disposal and
restoration of electrical and electronic
old devices and collection points from your local was-
te disposal company or from the manufacturer where
you purchased the product.
NOTE
Upon receipt of the goods, check the controllers and accesso-
ries and compare the data on the nameplate with the data on
the delivery note to ensure that the correct material has been
supplied.
We declare that the product described fully complies with
the directives 2014/35/EU, 2014/30/EU and 2011/65/EU. If you
need a detailed declaration of conformity, please contact us.