___________________________________________________________________________________
___________________________________________________________________________________
86 RG-5400 Subscriber router
SIP info (DTMF Relay) –
send messages to the opposite side via SIP in INFO requests.
flash
event is sent in
Application/dtmf-relay
extansion as
signal=hf;
SIP info (Broadsoft)
– send messages to the opposite side via SIP in INFO requests.
flash
event is sent in
Application/Broadsoft
extansion as
event flashhook
;
SIP info (SSCC) – send messages to the opposite side via SIP in INFO requests.
flash
event
is sent in
Application/sscc
extansion as
event flashhook
.
–
Payload type for RFC2833 packets
– payload type for packet transmission via RFC2833 (permitted
values: from 96 to 127);
–
Same payload type for transmission and reception
– option is used in outgoing calls for payload
type negotiation of events sent via RFC2833 (DTMF and Flash). When selected, event
transmission and reception via RFC2833 is performed using the payload from 200Ok message
sent by the opposite side. When unselected, event transmission is performed via RFC2833 using
the payload from 200Ok being received, and reception—using the payload type from its own
configuration (specified in the outgoing Invite);
–
Use voice activity detector –
when selected, enable voice activity detector;
–
Use echo cancellation
– when selected, use echo cancellation;
–
Use RTCP
– when selected, use RTCP for voice link monitoring:
Transmission period
– RTCP packet transmission period, in seconds;
Reception period
– RTCP message reception period measured in transmission period
units; if there is not a single RTCP packet received until the reception period expires, RG
5400 will terminate the connection.
SIP profile basic settings
–
Use STUN –
when selected, use STUN (Session Traversal Utilities for NAT) protocol in order to
define device public address (external NAT address). We recommend using this protocol for
device operation through NAT;
–
STUN server address –
STUN server IP address or domain name; specify an alternative server port
after the colon (default value is 3478);
–
STUN server polling period, seconds –
time period that defines transmission of a request to STUN
server. The less the polling period, the faster the response to the public address changes.
–
Transport
— used protocol of a transport level:
UDP (preferred ), TCP
– you may use UDP and TCP but UDP is recommended;
TCP (preferred), UDP
– you may use UDP and TCP but TCP is recommended;
Only UDP
– UDP is used only;
Only TCP
–TCP is used only.
–
Silence mode
– mode of ignoring SIP requests to subscribers that don’t have user accounts on
the device.
To apply a new configuration and store settings into the non-volatile memory, click
'Apply'
button.To
discard changes, click
'Cancel'
button
.
3.7.3.4
‘QoS’ submenu
In the 'QoS' submenu, you may configure Quality of Service functions.
