Elster Instromet DL230, Operating Manual

Page: 100 / 110

100 Faults
Message Description, process
I1-Alarm
I2-Alarm
The encoder connected does not supply any data
at times which may be invoicing-relevant.
b) Warnings:
Data restore DL230 batteries failed intermittently. As a result of
this, the time has not changed and measurement
acquisition has failed. All data has been saved.
This message appears when the battery is changed
and the old batteries are removed before the new
ones are connected. (see chapter 7.2, page 87).
Process using parameterization program "enSuite":

Set the DL230 clock
 Clear the status register
Outp.1 Error
Outp.2 Error More pulses need to be sent to the named output,
than its programming permits.
To eliminate the cause of this problem, use the
"Ensuite" parameterization program to
 either reduce the cp value of the output
 or increase the output frequency.
In both cases, the change must be aligned with the
device connected to the DL230.
I1-Warning
I2-Warning The encoder could not be read at the end of the
measurement period. The flow recording at this
point is invalid.
Update error An error in the cached software image was found
prior to the software update.
Softw. error This message is used for factory diagnostics.
Please contact the Elster customer service team
(see chapter 1.3 "Customer service").