10
Language of display
Activate the programming mode for addressing of the power supply unit at the
KNX bus
The display will be dimmed after 60 seconds if no key has been pressed during this
time. In addition, the backlight of the display will be switched off automatically if the
temperature inside the housing exceeds 50°C. Thus a high thermal load is avoided.
Line reset
In starting position, press key once to get into the
sector “Diagnostics”.
Press key once more in order to get into the sector
“Line reset”.
Move the cursor (flashing rectangle at right edge) to
the desired setting with the keys or
and confirm
with key
.
Yes:
Reset is activated. The line is switched to neutral and shorted. The
basic setting displays: “Reset is active!”
No:
Reset not activated. The power supply system works in normal
operation.
30 seconds:
A reset of 30 seconds is started. Afterwards, the line is supplied
with voltage as usual. During the reset state, which lasts 30
seconds, the basic setting displays: “Reset active: XX sec”
(countdown).
With key , you return to the previous menu level.
Data memory
In starting position, press key once.
Move the cursor (flashing rectangle at right edge) to
the “Data memory” menu with the keys and and
confirm with key .
elsner elektronik
KNX PS640+IP
Normal Operation
Diagnostics >
Line Reset
> ™
Data Memory >
Operating Data >
Language
Reset: Yes ™
No
30 seconds
Reset not active!
elsner elektronik
KNX PS640-IP
Normal Operation
Diagnostics >
Line Reset
>
Data Memory
> ™
Operating Data >
Language
> v
