20
Setting of parameters
Rain/Wind sensor KNX RW
• Status: 10.06.2021 • Technical changes reserved. Errors reserved.
7.3. Logic
AND Logic
OR Logic
7.3.1. AND Logic 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
Logic output sends “one 1 bit Object“:
Behaviour of the switching output
with release (selection depends on settings
made before)
• do not send telegram
• send status of the switching output
• if switching output = 1 => send 1
• if switching output = 0 => send 0
Communication objects logic inputs
do not release • release
Logic 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
not active • active
Transmission delay of the switching
outputs after power up and programming
5 sec … 2 h
Logic 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
not active • active
Transmission delay of the switching
outputs after power up and programming
5 sec … 2 h
1. / 2. / 3. / 4. Input
• do not use
• all switching events which the sensor
provides (see “Linkage inputs of the AND
logic”)
Logic output sends
• not
• one 1 bit object
• two 8 bit objects
Logic output sends
one 1 bit object
if logic = 1
object value
1 • 0
if logic = 0
object value
1 • 0
Communication object
AND Logic 1 sends
• in case of the change of logic
• in case of the change of logic to 1
• in case of the change of logic to 0
• in case of the change of logic and
cyclically
• in case of the change of logic to 1 and
cyclically
• in case of the change of logic to 0 and
cyclically
send cyclically every
(only if sending “cyclically”)
5 sec … 2 h