11
Installation and commissioning
Rain/Wind Sensor KNX RW
• Status: 10.06.2021 • Technical changes reserved. Errors reserved.
DANGER!
There is a risk to life from the live voltage on a 230 V device!
•
The cover must be screwed on in operation.
To remove it, the sensor can be simply pulled upwards out of the mount, against the
resistance of the fastening.
2.3. Notes on mounting and commissioning
Do not open the device if water (rain) might ingress: even some drops might damage
the electronic system.
Observe the correct connections. Incorrect connections may destroy the sensor or con-
nected electronic devices.
Fig. 15
With the 230V model, screw the cover on to
the underpart, to prevent unauthorised or ac-
cidental opening.
Fig. 16
Push the housing from above into the fas-
tened mount. The bumps on the mount must
snap into the rails in the housing.
Fig. 17
After installation, remove the protective sti-
cker on the wind sensor and the "distance"
sticker on the top of the cover.