10
Installation and commissioning
Rain/Wind Sensor KNX RW
• Status: 10.06.2021 • Technical changes reserved. Errors reserved.
20...32 V DC version
2.2.5. Mounting the sensor
Close the housing by putting the cover back over the bottom part. The cover must snap
in on the left and right with a definite “click”.
Fig. 13
1
Slot for cable connection to
the rain sensor in the housing
cover
2
Tension clamp for voltage
supply (20...32 V DC).
Massive conductors of up to
1.5 mm² or conductors with
fine wires. Terminal configu-
ration independent from po-
larity (+/- or -/+).
3
Opening for the cable for the
voltage supply and for bus ca-
ble
4
Slot for KNX clamp +/-
5
Programming pushbutton for
the teach-in of the device
6
Programming LED
2
3
1
5
6
4
Fig. 14
Make sure the cover and bottom part are
properly snapped together! This picture is
looking at the closed sensor from under-
neath.
Fastening