elsner elektronik 70391, Installation And Adjustment

Page: 13 / 18

11 Parameter setting
Door operator control module KNX A3-B2 • Status: 17.12.2019 • Technical changes and errors reserved.
Input as changeover switch:
If a button with switch function is assigned to the input, select the bus function
"Changeover Switch" and specify if the button should switch when pressed/released.
Input to shutter, blinds, awning or window control:
If the input to the drive control is used via the bus, select the bus function "shutter",
"awning", "blinds" or "window" and specify the button function and control mode.
Input as dimmer:
If the input is used as a dimmer, select the bus function "Dimmer" and specify the
button function, time interval (switching/dimming) and if requested, the repeat interval
for a long button press.
Send value • no change
• for change to 1
• for change to 0
• for change and cyclical
• for change to 1 and cyclical
• for change to 0 and cyclical
Cycle
(if sent cyclical)
5 s • 10 s • 30 s • 1 min • 2 min • 5 min • 10
min • 20 min • 30 min • 1 h • 2 h
Function Changeover Switch
Command when pressing the button • Switching
• do not send telegram
Command when releasing the button • Switching
• do not send telegram
Function Shutter / blinds / awning / window
Button function Up • Down
Up • Down • Up/
Down
On • Off • On/Off
Open • Closed •
Open/Closed (shutter)
(blinds)
(awning)
(window)
Control mode* • Standard
• Standard inverted
• Comfort mode
• Dead man's switch
Function Dimmer
Button function brighter • darker • brighter/darker
Time between switching and dimming
(in 0.1 s) 1...50; 5
Repeat the dimm command no • yes