elsner elektronik 70119, Installation And Adjustment

Page: 18 / 24

16 Setting of parameters
Brightness sensor KNX L • Status: 20.12.2019 • Technical changes reserved. Errors reserved.
Blocking
„Blocking“ only appears if using „Switching output sends on change“
If block of the switching output is used:
6.2.2. Twilight threshold value 1 / 2 / 3
Threshold value
If the threshold value is set per Parameter:
Switching output sends • not
• on change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
send cyclically every
(only if sending “cyclically”)
5 sec … 2 h
Use block of the switching output Yes • No
Use block of the switching output Yes
Evaluation of the blocking object • if value 1: block | if value 0: release
• if value 0: block | if value 1: release
Value of the blocking object before
1. communication 0 • 1
Behaviour of the switching output
with blocking • do not send telegram
• send 0
• send 1
Behaviour of the switching output
with release (Selection according to pre-
vious settings) • do not send telegram
• send status of the switching output
• if switching output = 1 => send 1
• if switching output = 0 => send 0
Threshold value setpoint per Parameter • Communication object
Threshold value setpoint per Parameter
threshold value in lux 0 … 1000; 200
Hysteresis of the threshold value in % 0 … 50; 20