EN - 15
liberoCONFIG
LI6003E
CONFIGURATION OF A LIBERO CX
3
3.2.5
Configuration mode
The configuration mode is used to set or change all logging features (profile).
liberoCONFIG is used for these settings.
Configuration is only possible if "ConF", "Strt" or the Profile-ID is displayed.
3.4.2
Logging
3.4.3
Alarm conditions
Display: New LIBERO
Cx
Unconfigured LIBERO Cx show "ConF" on the display.
Display: Configured
LIBERO Cx
Either "Strt" or the Profile-ID is shown on a configured but not started LIBERO Cx.
Start configuration
As soon as the LIBERO Cx is connected to the USB port, it switches to configuration mode.
Continue with 3.4
Configuring the LIBERO Cx
Configuration com-
pleted
After configuration remove the LIBERO Cx from the USB port.
Either "Strt" or the Profile-ID is shown on the display.
Communication
error
THE FOLLOWING CASES COULD CAUSE COMMUNICATION PROBLEMS:
• Bad USB extension cable
• Passive USB hub. Please use an active USB hub or connect the LIBERO
Cx directly to the PC.
Summary of Contents for Libero Cx
