159
Réglage uniforme de la largeur ou de la
longueur des points
Si le curseur est positionné à droite du dernier point de la
séquence programmée, l’ajustement de la largeur ou de la
longueur de point s’applique à toute la séquence.
Largeur de point:
z
Programmer 083, 094 et 083. (Le curseur doit être à
droite du dernier point de la séquence.)
x
Appuyer sur le côté du signe “–” sur la touche
“Largeur de point/position d’aiguille”.
c
Placer le tissu et le stabilisateur sous le pied et coudre.
Tous les points de la séquence auront la même largeur.
Longueur de point:
v
Appuyer sur la touche “Lecture mémoire droite” pour
déplacer le curseur après le dernier point de la
séquence.
b
Appuyer sur le côté du signe “–” sur la touche “Longueur
de point”. (un bip sonore retentit.)
REMARQUE: Il n’est pas possible d’ajuster
uniformément la longueur de point d’une séquence si elle
contient différents styles de points (points de passés et
points décoratifs ou points utilitaires).
n
Appuyer sur la touche “C” et la maintenir enfoncée.
m
Programmer 086, 087 et 086. (Le curseur doit être à
droite du dernier point de la séquence.)
,
Appuyer sur le côté du signe “–” sur la touche “Longueur
de point”.
.
Placer le tissu et le stabilisateur sous le pied et coudre.
Tous les points de la séquence auront la même longueur.
Einheitliche Einstellung der Stichbreite oder -
länge
Wenn der Cursor rechts vom letzten Stich in der
programmierten Abfolge steht, wird die Veränderung der
Stichbreite oder -länge für die gesamte Abfolge angewandt.
Stichbreite:
z
Programmieren Sie 083, 094 und 083. (Cursor muss
rechts vom letzten Stich in der Abfolge stehen.)
x
Drücken Sie die Taste für Stichbreite und Nadelposition.
c
Legen Sie Stoff und Verstärkungsunterlage unter den
Nähfuß und nähen Sie.
Alle Stiche innerhalb der Abfolge haben jetzt dieselbe
Stichbreite.
Stichlänge:
v
Drücken Sie die Speicherübersichtstaste - Rechts, um
den Cursor nach dem letzten Stich in der Abfolge zu
positionieren.
b
Drücken Sie "-" oder die Stichlängetaste. (Die Maschine
gibt einen PIEPTON von sich.)
ANMERKUNG: Die Stichlänge kann nicht einheitlich
innerhalb einer Abfolge verändert werden, wenn
unterschiedliche Sticharten (z.B. Federstiche, Zier- oder
Nutzstiche) enthalten sind.
n
Halten Sie die Taste C eingedrückt.
m
Programmieren Sie 086, 087 und 086. (Cursor must
rechts vom letzten Stich in der Abfolge stehen.)
,
Drücken Sie "–" oder die Stichlängetaste.
.
Legen Sie Stoff und Verstärkungsunterlage unter den
Nähfuß und nähen Sie.
Alle Stiche innerhalb der Abfolge haben jetzt dieselbe
Stichlänge.