Strona 8 z 11
rev. 1.0.1
USER MANUAL
:
G
T100
GPS MOTORCYCLE TRACKER
www.elmic.pl
,
5.
Set the center number
If you want to cut off/restore oil by SMS command, you have to set a center number firstly. Only the center number can
send the cut off/restore oil command to the device. You can set your own mobile number as center number.
The command for setting center number is:
CENTER,A,mobile number#
For example:
CENTER,A,15942703401#
If set successfully, there is an “OK” reply message.
NOTE
：
Only the SOS number can be used to set center number successfully.
6.
Delete the center number
SMS command to the device to delete the center number.
The command is:
CENTER,D#
For example:
CENTER,D#
If set successfully, there is an “OK” reply SMS.
NOTE
：
Only the SOS number can be used to delete center number successfully.
Only SOS phone number can send this command successfully to set the center number. There is only one center number
can be set.
7.
Check parameter setting
Send command to the terminal, you can check the parameter setting.
Command format:
PARAM#
e.g.: PARAM#
Information replied:
IMEI: 353419032348877 ---IMEI number of the device;
GPRS Interval: 10,10;
---GPS data uploading Interval;
SENDS:5;
--- the GPS working time when ACC is OFF;
SOS: 15942703401;
--- SOS numbers, maximum 3 SOS numbers can be set and used for alarm and monitoring;
Center Number: 15942703401;
---only 1 center number can be set and used for cutting off /restoring oil command;
Sensoralm: 10,3,1,180
--- detect 3 vibrations in 10s; the alarm delay is 180s;
Defense time: 10;
--- the defense delay is 10 minute;
TimeZone:E,8,0;
--- set time zone; default as E8.
The replied information contains IMEI number, GPRS Interval, SENDS, SOS, center number, sensor time interval, defense
time and time zone.
8.
Set GPS data upload interval
Upload by interval
The default upload interval is 20 seconds, which means every 20 seconds the terminal will upload its location data to the
platform. The interval can be set by sending SMS command:
TIMER,T1,T2#
(5≤T≤18000 seconds)
e.g.
TIMER,20,30#
It means when ACC is on, GPS data upload interval is 20 seconds; when ACC is off, GPS data upload interval is 30 seconds.
Upload by distance
Send SMS command:
DISTANCE,D#
(100≤D≤10000 meters)
e.g.
DISTANCE,300#
It means for every 300 meters, the terminal will upload GPS data to platform.
NOTE: if the upload interval is short, the GPRS current will add up. Please set the suitable upload interval.
9.
Corners upload (ON as default)
The terminal will upload GPS data to the platform when the vehicle is turning (the turning angle reaches the pre-set
value).
NOTE: if the speed is too low during turning, the GPS data will be not able to upload to the platform.
Send SMS command:
ANGLEREP,OFF#
to turn it off.
10.
Armtime interval
When the vehicle is turned off (ACC low) and stays off in 3 minutes, the terminal will enter arm status. During this status, if
the terminal detects 6 vibrations (default) and the vehicle still stays off (ACC off) in 30 seconds, it will activate vibration
alarm.
Send SMS command:
DEFENSE,T#
(1≤T≤60 minutes)
e.g.
DEFENSE,15#
It means after 15 minutes the vehicle is turned off, the terminal will enter defense mode.
