Technical Support Line +44 (0)23 9269 6638 (Option 3)
PAK200218 Iss 05B Oct 2012
©2012 ELMDENE INTERNATIONAL LTD
O
PTIONS
S
ELECTION
Figure 1: Connections and Jumper Link Options
Note: Factory Default is 15 minute Cut-off, flashing LED’s, SAB Mode, Tone 4
Sound Cut-off Timer
The sounder will automatically stop sounding after the time period selected by the Sound Cut-off Timer links, J1/J6,
irrespective of the status of the sound trigger (R-) input. The 5s option is provided to reduce nuisance noise during testing.
Comfort LEDs
Twin comfort LEDs may be configured for alternate flashing, permanently on or permanently off by selection of J2/J7. When
enabled, the LEDs flash at a rate of approximately 1Hz.
SAB Mode
In SAB mode the sounder can draw current from both the control panel and the battery. The siren will self-activate if either of
the tampers are activated.
In SCB mode the sounder draws the majority of its current from the battery to minimise drain on the control panel. This allows
the user to connect multiple units to a control panel without overloading it. Select SCB mode using the J8 link (Figure 2.0). In
this mode the sounder will NOT self activate under a tamper condition but the tamper condition will still be signalled back to
the control panel. The control panel can then trigger the siren using the R– line.
Note: The siren will self-activate if the supply lines are cut in either mode.
TIMER
LEDS
J1 J6
J2 J7
ENG
HEALTHY
SAB
SCB
J4 J5
TONES
J8
H+
H-
R-
ST-
TS
TR
BAT+
BAT-
3
J1
2
TONES (J4/J5)
3
4
1
J6
TIMER
LEDS
10m
3m
5s
J2
J7
15m
ON
OFF
FLASH
OFF
