165
SD542-9004 (Page 2/2)
R1-R1 - Define the Radio Bus by connecting receivers one to the othe
r
E5 - Connect the transmitter to the closest receiver
CONTROL PANEL SW CONFIGURATION
By
using
the
keypad
or
the
Hi-Connect
programming
software,
configure
the
output
as
follows
:
- OUTPUT TYPE = OUTPUT N.L.
- CUSTOMIZE = O. PULSED COMM.
Apply a short press to "Connect" on receiver 1. Its LED will start flashing (R1)
.
While
the
LED
is
flashing,
press
"Connect"
on
receiver
2
(R1).
To
confirm
the
connection,
the
LED
of
receiver
2
will
only
flash
once
and
the
LED
of
receiver
1
will
stop
flashing;
after
establi
-
shing
a
connection,
both
modules
will
respond
(the
lighting
modules
will
flash
or
the
shutter
will move briefly).
Briefly
press
5
times
the
temporary
pushbutton
connected
to
the
transmitter
(E5).
The
transmitter LED will start flashing for 30 seconds, to indicate that it is waiting for connection.
While the transmitter LED is flashing, shortly press the "connect" hole of the closest receiver
with the tip of a pencil.
The
transmitter
LED
will
stop
flashing.
The
light
connected
to
the
module
will
flash
or
the
shutter will move briefly
.
Warning!
The receiver must be powered on.
M6 - Configuring the transmitter for centralised control sending
M10/M11/M20 - Define whether the control is for the lights,
shutters or both
M3/M4 - Define the action: Turning On or Up movement / Turning
Off or Down movement
Briefly press 10 times the transmitter temporary pushbutton (Configuration Menu (M)).
The transmitter LED will flash rapidly
.
While the LED is flashing, briefly press the temporary pushbutton (6) 6 times.
The LED will flash 6 times to confirm the centralised mode.
Briefly press the transmitter temporary pushbutton 10 times (Configuration Menu (M)).
The transmitter LED will flash rapidly
.
While the LED is flashing, apply
:
- For the LIGHTS: a short press to the temporary pushbutton 10 times (10) (default).
- For the SHUTTERS: a short press to the temporary pushbutton 11
times (11).
- For the LIGHTS and SHUTTERS: a short press to the temporary pushbutton
20 times (20).
The LED will flash to confirm: 10, 1, 10 times – respectively
.
Briefly press the transmitter temporary pushbutton 10 times (Configuration Menu (M)).
The transmitter LED will flash rapidly
.
While the LED is flashing, apply
:
- For Turning On (or Shutters Up movement): 3 short presses to the temporary
pushbutton (3).
- For Turning Off (or Shutters Down movement): 4 short presses to the temporary
pushbutton (4).
The LED will flash to confirm: 3 or 4 time
s
