8
Light Kit – 7083/7084
The Light Kit provides illumination specifically for the areas
targeted by EXM monitors. The Light Kit is mounted on top of the
discharge elbow and follows the aim of the monitor. Installation
instructions are included with the light kit.
7083 – Light Kit with light control module and light bar included
7084 – Light Kit with light control module only
CAN Connector Kit - 37221000
This kit provides the wired connectors needed to branch off the
main CAN communication line, and allows you to connect
another EXM component between the two EXM components at
the ends of the main line.
One kit is needed for each additional
EXM component that is added to the main CAN line.
VALVE
Unibody Valve with E3F Electric Actuator -
The Unibody water valve provides a convenient remote on/off
and preset valve positioning control of the water supply to the
. This allows the operator complete control of the
unit from the safety of the vehicle cab or handheld radio
controller*. The water valve motor speed prevents water hammer,
yet closes quickly enough to help preserve the limited on-board
water supply. The electric actuated Unibody Valve may be
powered with 12 or 24 Volts.
*Valve must be wired for CAN communication with the monitor
to allow operation from an “RF ONLY” enabled controller.
