26
Important:
If using a Position Feedback Display with an extended travel monitor,
the position display will need to be calibrated after setting new limits.
F. Keep-Out Zones
Keep-Out Zones are used when it is desired to restrict the motion of the monitor to a smaller
more specific range than that set during system calibration. Keep-Out Zones are different
from travel limits in that they do not restrict motion completely in any one direction. Keep-
Out Zones can be set to allow the monitor to move above a certain zone or beside the zone
to either the left or right.
Lower-Right Keep-Out Zone - The Right Keep-Out Zone will prevent the monitor from
moving down and to the right into a specified zone (reference figure 1)
o
Put the EXM system into
Setup Mode
(reference Part B of the Operating Instructions
section).
o
Move the monitor to the upper left corner of the keep out zone.
o
The Keep-Out Zone should be set within the previously set monitor calibration
points. If a Keep-Out Zone is set outside the intended operating area, operation of
the monitor may be unpredictable.
o
Hold the PRESET button, then press the OPEN button, and then release both.
o
When the EXM system is taken out of Setup Mode, the monitor will be prevented
from moving below and to the right of this point.
Lower-Left Keep-Out Zone - The Left Keep-Out Zone will prevent the monitor from
moving down and to the left into a specified zone (reference figure 1)
o
Put the EXM system into
Setup Mode
(reference Part B of the Operating Instructions
section)
o
Move the monitor to the top right corner of the keep out zone
o
The Keep-Out Zone should be set within the previously set monitor calibration
points. If a Keep-Out Zone is set outside the intended operating area, operation of
the monitor may be unpredictable.
o
Hold the PRESET button, the press the CLOSE button, and then release both.
o
When the EXM system is taken out of Setup Mode, the monitor will be prevented
from moving below and to the left of this point
Lower Right Zone:
Top left corner
Lower Left Zone:
Top right corner
Lower Left
Zone
Left Travel Limit
Lower Right
Zone
Right Travel Limit
