LINK PARAMETERS - Label Lin - EWDR 985/CSK (LX) ONLY - SEE PAGE 12
folder nAd For each day of the week d0…d6/Ed parameters Evento E00…E03 can be displayed/programmed (see also nad table).
PAR.
DESCRIPTION
RANGE
DEFAULT
VALUE*
LEVEL**
U.M.
OAO
High and low temperature alarm delay after dis-
abling digital input (door closed)
0...10
0
2
hours
Alarms-AL label
tdO
Time out after alarm signal when digital input is
disabled (door open)
0...250
0
2
min
tAO (5)
Temperature alarm delay time
0...250
0
1-2
min
dAt
Alarm for defrosting ended due to time out.
n=alarm not active y=alarm active
n/y
n
2
flag
EAL
External alarm to lock controllers n=does not lock,
y=locks
n/y
n
2
flag
AOP
Polarity of alarm output: 0 = alarm active and out-
put disabled; 1 = alarm active and output enabled
0/1
1
2
flag
PbA
Configuration of temperature alarm on probe 1
and/or 3:
0=on probe 1 (thermostat control)
1=on probe 3 (display)
2=on probe 1 and 3 (thermostat control and display)
3=on probe 1 and 3 (thermostat control and display) on external threshold
0/1/2/3
0
2
num
SA3
Probe 3 alarm set point
-50.0...150.0
50
2
°C/°F
dA3
Probe 3 alarm differential
-30.0...30.0
2.0
2
°C/°F
dEA
DEA= device number within the family
(valid values: from 0 to 14)
FAA
FAA= device family (valid values: from 0 to 14)
The value couple FAA and dEA represents the network address of the device and it is indicated in the following way: "FF.DD" (where FF=FAA and DD=dEA).
0...14
0
1-2
num
Night & Day Control-
nAd label
E00
Functions enabled during events;
0=control disabled 1=reduced set point
2=reduced set point+light
3=reduced set point+light+aux / 4=instrument off
0...4
0
1-2
num
E01
Hours/minutes of start of intervention. Starting
from this time, the “NIGHT” mode will be enabled.
The duration is determined by EO2
0...23/0...59
0
1-2
hours/min
E02
Duration of event. Sets the duration of the event
that begins at time E01 determined by value E00
0...99
0
1-2
hours
E03 (6)
Blocking/unblocking daily or holidays defrosting.
0= “work days” defrost sequence defined by
parameters dE1...dE8;
1= “festive/holidays” defrost sequence defined
by parameters F1...F8
0/1
0
1-2
flag
EWDR 983-985/CS (LX) - EWDR 985/CSK (LX)
6/12
Light & digital inputs
Lit Label
*EWDR 985/CSK (LX)
ONL
Y
dSd
Light relay enable from door switch.
n = door open, light does not turn on;
y = door open, light turns on (if it was off)
n/y
y
2
flag
dLt
Light relay disabling delay after closing door if
“dSd”=y
0...31
0
2
min
OFL
Light relay disabled even if disabling delay
“dLt” is active
n/y
n
2
flag
dAd
Delay in enabling digital input
0...255
0
2
min
dOd
Digital input switches off loads
n/y
n
2
flag
dOA*
Forced behaviour from digital input:
0=no enabling;
1=compressor enabled
2=fans enabled;
3=compressor and fans enabled
0/1/2/3
0
2
num
PEA*
Enables forced behaviour from door light and/or
from external alarm
0=function disabled;
1=associated with door light
2=associated with external alarm;
3=associated with door light and external alarm
0/1/2/3
0
2
num
dCO*
Delay in enabling compressor with consensus
0...250
0
2
min
dFO*
Delay in enabling fans with consensus
0...250
0
2
min
Communication
Add label
