JA09252018
7
www.elitescreens.com
2.
RF remote control
: The RF remote does not require line-of-sight and can be used up to 50ft.
Press the
Down
button to Drop the screen
Press the
Stop
button to Stop the screen
Press the
UP
button to Retract the screen
How to program your RF remote to your screen
How to deprogram the RF remote and delete the code
3. Extended IR sensor:
Plug the extended IR sensor into the port located on
the left side end of the screen. (see below image for precise port location)
Note:
Cover will need to be opened to expose inputs
4.
5-12 volt trigger:
Connect the mini jack plug end to the 5-12 volt trigger port (see image
above) and the other end to your projector’s output port to synchronize the projector’s
power cycle to your screen. Connection to the projector’s trigger port is not included.
Refer
to the diagram below for wiring instructions. Contact your projector’s manufacturer
for proper 5-12 volt trigger cable information.
The screen should automatically DROP when the projector is turned ON and RETRACT
when the projector is turned OFF. You can test the operation using a 9-volt battery.
Press and hold the UP button
for more than 3 seconds.
Stop pressing the UP button upon
hearing a beeping sound. This indicates
you are in the programming mode.
The receiver will
beep three times.
RS485 port
Press and hold the UP button
for more than 3 seconds.
Plug the screen’s power
cable into a power outlet.
Stop pressing the UP button upon
hearing a beeping sound. This indicates
you are in the programming mode.
Press the UP button
The receiver will beep
three times to confirm
the programming.
RF remote is ready to be used.
Plug the screen’s power
cable into a power outlet.
Press the DOWN button
Code has been deleted and RF
remote is no longer operational
5-12 v projector
trigger port
Extended IR
sensor port
RS485
port
