JA09252018
6
www.elitescreens.com
8. Once the
end covers (F)
have been attached, finally insert the
End cover caps (E)
to conclude the installation.
Standard controls included with the Evanesce Tab-Tension 2 CineGrey 5D
A. RF remote
B. IR remote
C. Extended IR
sensor
D. 5-12 volt
projector tirgger
E. Power Cord
Screen Operation
Electric current
: The screen operates on AC 120V AC at 60hz/ .97 A. (US/Canada/Mexico only)
Caution
:
The screen’s motor is equipped with a thermal heat protector which will cause the motor to stop
running and prevent overheating if it is in continuous use for more than 4 minutes. When this occurs, please
allow the motor to cool down and use again after 15 minutes.
1. Plug the screen’s power cord
to the screen and the 3-prong
side to a power outlet.
2. Once the screen has power you’ll be able to control it with
the controls included as explained next.
Control System
The
Screen
has equipped with
Infrared
and
Radio Frequency
receivers and a wall switch control panel. You can
control the screen’s
UP/STOP/DOWN
positions utilizing either the IR (Infrared) or RF (Radio Frequency) remotes
or the wall switch control panel.
1.
IR remote control:
The IR remote control requires line-of-sight to the IR sensor. Make sure to point the IR
remote directly to the
extended IR sensor
(see step 3 for installation).
Note
: a. The IR remote has a range of 15 feet.
b. The IR sensor must not be covered or blocked.
Fig 13
Fig 14
Cover the end
cover holes with
the end cover caps
