Rev.010521DT (DS0189)
4
Unrolling the screen material
Two people recommended
Back side of screen material
Weighted object
Back side of screen
Note: Backside facing up
(frontside facing down)
Front side of screen
Clean surface area
ATTENTION: Put the gloves on when handling the screen material to avoid touching it with your bare hands.
1
. Put on the supplied pair of white gloves.
This is to avoid leaving oily handprints on
the screen surface which are not
removable.
2.
Remove the screen material from the tube
and place a small suitable weighted object at
the end of the material.
3. Lay the material face down, two people
carefully lift the rolled end and slowly rotate
the material clockwise.
4. Insert the corresponding fiberglass rods on
thru the sleeves on the edges of the material.
Fiberglass rod
a1 = a2
≒
35mm
Backside of screen
22
Note: Please install the six fiber rods into the frame
1
. Carefully and gently place the assembled
frame on top of the screen material.
DO NOT
allow the angle edge of the frame to
come in direct contact with the material to
avoid puncturing it.
2.
Adjust the distance between the edge of the
frame and the material (a1 = a2) to 1.4”/35 mm
Backside of screen
a1=a2
a2
Backside of screen
a1
3
.
Screen
Material Installation
