Elite Greenhouses WIDE MAXIM, Instructions & Illustrations

Page: 11 / 28

5. Slide three bolts into the bolt channel at the top of the two vertical glazing bars and secure the
third one to the roof corner bars by inserting the bolt through the punched hole in the flange.
6. You can now attach the short horizontal angle brace to the top bolt of the gusset plate and to
the other bolts in the glazing bars you inserted in 6, above.
7. Now attach the longer horizontal brace to the top bolt hole (of 3) in the side corner bar, and
also to the vertical glazing bars using the 1
st
bolt inserted in the glazing bars. This longer
horizontal bar is attached to the same hole as the diagonal angles.
8. Check that all angles between built in base cill and the vertical members are at right angles
and that the glazing bars are right into the angle cill at the bottom. (Key point).
9. Tighten all nuts.
10. Slide two extra bolts into the built in base cill. This will be used later to attach the angle base
leg. This angle is 400mm long and has 6 holes in. It is the end with one elongated hole each
side that bolts to the built-in-base.
11. Slide a bolt into the bolt slot in the built in base section, one at each end. Attach the corner
bracket/angle base leg so that it is pointing downwards. If you are fitting your greenhouse on
to soft ground, then do not fit the corner bracket/angle base leg yet. If you are on a patio, you
will need to cut the bracket off level with the bottom of the built in base then before fitting,
then slide extra bolts into the bolt channel to be attached to anchor brackets (generally 1 every
2’). If you are on soil, the bracket/angle base leg will go into the ground at general assembly.