Elite Greenhouses TITAN 1200, Instructions & Illustrations

Page: 8 / 32

SIDE FRAME ASSEMBLY
From the pack you require:
If you have ordered a built in base, then follow the section at the back of the booklet in conjunction with the
instructions for each sub assembly.
Pack of side bars marked “side bars”
Pack of gutters and cills marked “side”
Pack of angles marked “side”
For greenhouse of 14’ or longer, the gutters, ridge and cills are in a separate pack wrapped in poly-
thene.
From the pack of fittings you need: nuts and bolts, glazing beading.
Procedure : For the point of this plan we have used a 12’ x 12’ side as an illustration. The procedure
is identical for a 10’ x 12’ and 20’ x 12’ apart from needing more or less side bars, nuts and bolts,
glazing beading and longer or shorter gutters and cill.
(Key point).
If you have purchased a partition with your greenhouse you will have 2 less roof and 2 less side
bars. These are replaced with an extra set of corner bars. You must decide where the partition is to
be situated and at that point leave out one side bar on each of the side frames.
(Key point). The par-
tition is constructed when the greenhouse is fully erected prior to glazing. Full details of this proce-
dure given later in the booklet, but for the time being do nothing apart from the omission of the side
bar.
If you have not purchased a partition disregard this and future notes relating thereto.
You need for each frame: 1 gutter/eaves, 1 cill, 2 diagonal angles and 5 side bars. (N.B. For the
longer sides you have 4 diagonal angles per frame).
Before assembling any sections slide the required number of bolts into the glazing bars.